Tuning Menu – Shipping condition
30
Exit
Geomagnetic
AV2 out Analogue
Off timer Off
DVB timer lock Off
Setup menu
DVB Timer programming
Tuning menu
Access
Select
Exit
Child lock Off
Owner ID
Analogue manual tuning
New services message Off
Q-Link Download TV - > VCR
Tuning menu
Auto setup
Shipping condition Access
Shipping condition
All tuning data will be erased
EXIT : To exit
SETUP : Return to tuning menu
Shipping condition allows you to reset the TV to its original condition, i.e. no channels tuned in.
This is useful, for example, if you move to a different area when you will probably want the TV to tune
itself to your new local stations.
This can be done either through the Shipping condition menu or through the Auto setup menu.
The Shipping condition menu will reset all data, clearing all tuning information and resetting all control
levels back to factory settings.
You may need to adjust your VCR or programme position '0' VCR after operating the Shipping condition
menu - refer to page 36.
Open the Setup menu
Move to Tuning menu
Access Tuning menu
Move to Shipping condition
Access Shipping condition
Press OK to start
You will be given a warning.
Press, to confirm, each time that you
are asked, "Are you sure?"
Switch TV off and wait for a few seconds.
Switch TV on again.
Auto setup will begin, stations will be located, sorted and stored ready for use.
