33
● Dynamic Recording
This item lets you select the cameras for dynamic recording
mode in non-alarm condition.
If five or more cameras are connected to the video multi-
plexer, the channels selected for dynamic recording are
recorded with priority.
1. Move the cursor to DYNAMIC REC SETUP by pressing
the C or D button and then press the [HOME/SET] but-
ton.
The DYNAMIC REC SETUP menu as shown in the figure
appears on the monitor screen.
2. Move the cursor to the PRIORITY column to be record-
ed with dynamic recording for the camera number by
pressing the C, D, A, or B buttons.
3. Select either ON or OFF by pressing the - or + but-
ton.
OFF: Disables recording images with priority.
ON: Enables recording images preferentially over other
input images.
The factory default settings are OFF.
4. Repeat steps 2 and 3 above to set other cameras.
Note: It is recommended to select up to 2 cameras.
5. When satisfied with all of the above steps, press the
[SET UP/ESC] button to execute the selection and
return to the previous REC OUTPUT SETUP menu.
Note: Recording is not enabled in dynamic recording
mode when EXT4 is selected for MODE 9 in the
REC MODE SETUP menu.
● Recording Mode Setup
This item lets you select a recording mode on the time
lapse VCR.
1. Move the cursor to REC MODE SETUP by pressing the
C or D button and then press the [HOME/SET] button.
The REC MODE SETUP menu as shown in the figure
appears on the monitor screen.
2. Move the cursor to the MODE parameter in the menu by
pressing the C or D button.
3. Select a mode number by pressing the - or + button.
MODE 0: Normal recording mode
MODE 1 - 8: Time Lapse Mode (VCR without camera
switching pulse)
MODE 9: Time Lapse Mode (VCR with camera switch-
ing pulse)
The factory default setting is “0”.
Note: To select MODE 1 - 8, you must first complete the
settings described below.
Recording Mode Setting Details
You can assign the camera switching timing to any one of
MODE1 to MODE8 when using the VCR without camera
switching pulse.
1. Move the cursor to the desired MODE number to be
assigned by pressing the C or D button.
2. Press the [HOME/SET] button to move the cursor to the
right in the switching timing column.
Note: The cursor does not move to this column
when MODE 0 is selected in this table.
The value is fixed to 1 in this column.