13
STARTUP
Onscreen display of NO SIGNAL displays on the center of the
screen as shown below, when there is no input signal.
Onscreen display of
VIDEO LOSS displays on the center of the
screen as shown below, when currently used input is discon-
nected.
Note:
• Press the AUTO button, when screen resolution is
changed from the connected PC.
When changing the resolution setting, there are cases
that auto tuning will not be completed.
(Refer to page 19)
Onscreen Display
S-VIDEO
VIDEO
COMPONENT
PC
S-VIDEO IN
VIDEO IN
COMPONENT IN
PC IN
Video Input
Before operating this monitor, confirm that the camera, other video sources and peripherals are connected correctly and securely.
When input signal is being detected, onscreen display of
PROCESSING appears on upper left portion of screen and
performs normal video display.
Note:
• During onscreen display of PROCESSING, all buttons
(except POWER button) are disabled. All buttons are
enabled after onscreen display of PROCESSING has
disappeared.
When picture is set to PC input, pressing the
AUTO button initiates
auto tuning of picture size and position.
Onscreen display of AUTO TUNING displays on the center of the
screen as shown below.
NO SIGNAL
AUTO TUNING
VIDEO LOSS
1. Turn on the monitor by pressing the
POWER button.
The power indicator lights up in green.
2. Select the desired input to be displayed by pressing the INPUT
SELECT button.
Onscreen display of the input signal currently on use displays
for approximately 2 seconds on upper left portion of the moni-
tor screen.
VIDEO
S-VIDEO
PC COMPONENT
3. Press the INPUT SELECT button to select the desired input
signal while it is being displayed.
Pressing the button repeatedly displays input in the sequence
shown below. Onscreen display of selected input appears for
approximately 3 seconds.
