PCAN-Dongle (ISO) – User Manual
When using this option, the 5-Volt supply is directly connected to
the power supply of the PCAN-Dongle (coming from the PC) and is
not fused separately. The ISO version of the Dongle contains an
interconnected DC/DC converter. Therefore the current output is
limited to about 50 mA.
Attention! At this procedure a special care is indispensable
since there is a short circuit danger. The PCAN-Dongle could be
destroyed and/or the power supply or electronics of the PC or
other components connected could be damaged.
Important note: PEAK-System Technik GmbH does not give
guarantee on damages which have resulted from application of
the option described in this section.
Procedure:
1. In order to access the PCB, open the case of the PCAN-
Dongle by cautiously levering the latches on both sides (risk
of breakage!), e.g. with a flat tip screwdriver.
2. Set the solder bridges on the PCAN-Dongle PCB according
to the desired settings. Figure 2 and Figure 3 show the
possible positions of a solder bridge.
8
