C2676M (9/07) 15
Reassembling the Unit
1. Replace the chassis cover using the screws you removed from the sides and rear of the unit (refer to
Figure 14).
Figure 14. Replacing the Chassis Cover
2. Attach the silver product label that came with your upgrade kit to the inside of your DVR’s front
door.
a. Remove the paper backing from the product label.
b. Carefully place the label, adhesive-side down, on a free section of the inside of the door.
c. Press down firmly to ensure that the label properly adheres to the inside of the door.
NOTE: In the event that your unit or its components require service, specific labels must be present
and appropriately affixed to the unit’s door. Pelco product support personnel use these labels to
identify the exact components installed in your system. A separate product label is required for each
upgrade component installed on the DX4500/DX4600.
3. Reinstall the unit in a rack enclosure if necessary, and reconnect all of the cables and peripheral
equipment you removed earlier.
4. This completes the reassembly of the DX4500/DX4600.
5. To complete the HDD installation, refer to Formatting on page 16.
