GENERAL OPERATION
1. Press STANDBY ON
y
on the set to switch on.
2. Press SOURCE once or more to select your desired function:
CD • VCD, FM, MW, TAPE
3. Press STANDBY ON
y
to switch the set to standby.
Helpful hints :
– To change from TAPE to
CD • VCD,
FM or MW source, or when you are switching off the set:
first, make sure you press the tape
STOP
9
key to end playback and all the cassette keys are
released.
– The tone, sound settings, tuner presets and the volume level (up to a maximum volume level of
VOL 20
) will be retained in the set's memory.
1. Adjust the volume with the VOLUME control.
= Display shows the volume level and a number from 0-32.
2. MAX SOUND
To enhance the bass response: press MAX SOUND once or more to
switch on / off.
= MAX SOUND-key backlight lights up when MAX SOUND is
turned on.
Helpful hints :
– MAX SOUND can be used when you play CD, VCD, FM, MW and TAPE
source.
– Some discs might be recorded in high modulation, which causes a distortion at high volume. If this
occurs, deactivate MAX SOUND or reduce the volume.
3. EQUALIZER
To adjust the bass, mid and high frequencies, press EQUALIZER once
or more (or press EQ on the remote control), then rotate VOLUME
within 3 seconds to adjust each level.
=Display briefly shows
,
, or
level (-5 to
+5) or
.
Helpful hints:
– EQUALIZER can be used during CD, VCD, FM, MW and TAPE
source.
– To prevent sound interference the bass control options operate exclusively.
You cannot combine the bass from EQUALIZER with MAX SOUND
ADJUSTING VOLUME AND SOUND
SWITCHING ON AND OFF
11
English
AZ 2536/01 page 11
AZ2536_01 eng 4/7/2004 05:51 PM Page 11
