15
English
Setting Up your DVD/VCR
8 Press the MENU button to exit.
Adding/Deleting Channels
1 Press the VCR button,then the MENU but-
ton.
2 Press the PLAY B or STOP C button to
select INITIAL,then press the FF g button.
3 Press the PLAY B or STOP C button to
select CH TUNING, then press the FF g
button.
4 Press the PLAY B or STOP C button to
select MANUAL,then press the FF g but-
ton.
5 Press the PLAY B or STOP C button to
select POSITION,then press the FF g but-
ton.
6 Press the PLAY B ,STOP C button or
numerical key pads button to select your
desired position number, then press the FF
g button.
7 Press the PLAY B or STOP C button to
select SKIP,then press the FF g button to
select [ON].
● To memorize the channel again, press the FF
g button. ON will change to OFF.
a will be displayed.
6 Press the PLAY B or STOP C button until
the channel move to another position num-
ber,then press the FF g button.
Channel Reprogramming
You can replace two channels.
1 Press the VCR button,then the MENU but-
ton.
2 Press the PLAY B or STOP C button to
select INITIAL,then press the FF g button.
3 Press the PLAY B or STOP C button to
select CH TUNING, then press the FF g
button.
4 Press the PLAY B or STOP C button to
select MOVE,then press the FF g button.
5 Press the PLAY B or STOP C button to
select your desired position number,then
press the FF g button.
● You cannot select a position number where “-
-” appears next to the number.This is because
SKIP is set to [ON] for this position number.
7 Press the MENU button.
a will be displayed.
