18
• [3D] - Select a virtual surround sound
effect that is produced from the left and
right audio channels.
• [Movie Mode] - Select a sound effect for
movies.
• [Music Mode] - Select a sound effect for
music.
[Night Mode]
Make loud sound level softer and soft sound
level louder so that you can watch the DVD
movies at a low volume, without disturbing
others.
• [On] – Enjoy quiet viewing at night.
• [Off] – Enjoy surround sound with a full
dynamic range.
Note
Applicable only to Dolby Digital encoded •
DVD.
Video setup
1 Press SETUP .
» [General Setup] menu is displayed.
2 Press to select [Video Setup] , then
press
.
3 Select an option, then press OK .
4 Select a setting, then press OK .
To return to the previous menu, •
press
.
To exit the menu, press • SETUP .
To return to the previous menu, •
press
.
To exit the menu, press • SETUP .
[Analogue Output]
Select an analogue setting based on the audio
device that is connected through the analogue
audio jack.
• [Stereo] - For stereo output.
• [LT/RT] - For surround sound output
through two speakers.
[Digital Audio]
Select a digital setting based on the digital
amplifi er/receiver that is connected through
the digital jack (coaxial/digital).
• [Digital Output] - Select a type of digital
output.
• [Off] - Disable digital output.
• [All] - Support multi-channel audio
formats.
• [PCM Only] - Downmix to two-
channel audio format.
• [LPCM Output] - Select the LPCM
(Linear Pulse Code Modulation) output
sampling rate.
• [48kHz] - For discs recorded at
sampling rate of 48 kHz.
• [96kHz] - For discs recorded at
sampling rate of 96 kHz.
Note
• [LPCM Output] setting is only available if the
[Digital Output] is set to [PCM Only] .
The higher the sampling rate, the better the •
sound quality.
[Volume]
Set the default volume level when you play a
disc.
1. Press OK .
2. Press
to set the volume.
3. Press OK to confi rm and exit.
[Sound Mode]
Select a preset sound effect to enhance the
audio output.
EN
EN.indd Sec1:18EN.indd Sec1:18 2009-7-29 11:27:492009-7-29 11:27:49
