18 EN
Setup
Audio setup
[Analogue Output] - Adjust this setting for audio output through AUDIO OUT.
• [Stereo] - Compress multi-channel Dolby digital sound to stereophonic sound output through
AUDIO OUT FRONT L/R.
• [LT/RT] - Compress multi-channel Dolby digital sound to 2-channel surround sound output
through AUDIO OUT FRONT L/R.
• [Multi Channel] - Enjoy Dolby digital sound output through AUDIO OUT 5.1 channels.
[Digital Audio] - Adjust this setting for audio output through COAXIAL/DIGITAL OUT.
• [Digital Output] - Select a type of digital output.
• [Off] - Disable digital output.
• [All] - Support multi-channel audio formats.
• [PCM Only] - Downmix to two-channel audio signal.
• [LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
Note
•
[LPCM Output] setting is changeable only when [Digital Output] is set as [PCM Only].
The higher the sampling rate, the better the sound quality.
•
[HDMI Audio] - Enable or disable the audio output through HDMI cable.
[Audio Sync] - Set a delay time for audio output when you play a video disc.
[Volume] - Set the default volume level.
[Sound Mode] - Select a preset sound effect.
[Speaker Setup] - Optimize the surround effect for the connected speaker system.
• [Front Speaker], [Center Speaker] and [Rear Speaker]
Select • [Large] when the speakers support the output of low frequency signal (lower than
120 Hz), otherwise select [Small].
Select • [Off] (This option is not available for [Front Speaker]) to mute the speaker(s).
• [Subwoofer] - Mute or unmute the subwoofer.
• [Speakers Volume] - Increase or decrease the volume level of each speaker.
• [Speakers Delay] - Set the delay time for each speaker.
General
Analogue Output
Digital Audio
HDMI Audio
Audio Sync
Volume
Sound Mode
Video
Audio
Preference
Stereo
Off
Night Mode
On
Speaker Setup
'93BB80LQGE 30
