Philips HX9882/33 Manual

next previous

Battery recycling

HANDLE CONTAINS A NICKEL CADMIUM BATTERY. BATTERY

MUST BE RECYCLED OR DISPOSED OF PROPERLY.

ThebatteryinsideyourSonicarecannotbereplaced,butiseasily

removedforrecycling.Attheendofproductlifeandpriorto

disposal,pleaseremovethebatteryfromthehandlebyfollowingthe

instructions below.

Please note that this process is NOT reversible.

Donotthrowtheapplianceawaywiththenormalhouseholdwaste

attheendofitslife,buthanditinatanofcialcollectionpointfor

recycling.Bydoingthisyouwillhelptopreservetheenvironment.

Removing the batteries

Please note that this process is not reversible.

To remove the batteries yourself, you will need a at-head (standard)

screwdriver. Basic safety precautions should be observed when following

the procedure outlined below. Be sure to protect your eyes, hands, ngers

and the surface on which you are working.

CAUTION

Cautionshouldbeexercisedwhenusinganyhouseholdtools(suchasa

screwdriver)toremovethebattery.

1 Depletethebatteryofanychargebyremovingthehandlefromthe

charger, turning the Sonicare on and allowing it to run until it stops.

Repeat this step until the product will no longer operate.

2 Remove the nut from the brush head and place it onto the handle.

Tightenthenutontothehandle(A)untilthehousingcomesloose

andthenpullthenutforward(B).

The handle internals will come out of the housing along with the nut.

3 Insert a screwdriver between the electronic circuit board and the

plasticpartclosetoeachendofthebattery;twistandbreakthe

connectionbetweenthebatteryandtheelectroniccircuitboardin

2 locations.

4 Separatetherechargeablebatteryfromtheappliancebymeansofa

screwdriver.

Please note that this process is NOT reversible.