2.To activate pairing mode press and hold the multi function button S1until the
LED starts flashing red and green alternately. The HS will remain in pairing
mode for 4 minutes, to resume pairing after 4 minutes repeat the steps
above.
3.Follow the operating instructions for your mobile phone to start the pairing
process.Typically this involves accessing a menu called “Setup”, “Bluetooth”
or “Connectivity”and selecting the option to discover or search for Bluetooth
devices.After several seconds search time your phone should indicate that
it has found the“Philips SHB1300/61”
4.Upon selecting the headset on your mobile phone typically you will need to
confirm the pairing and enter a passkey or PIN. Please enter the headsets
PIN “0000” (4zeros).
The headset LED will flash green every 3 seconds, indicating successful pairing.
If your phone asks whether you want to change the headsets name, you may
confirm the “Philips SHB1300/61” name or change it. You are now ready to talk!
If pairing does not occur as expected turn the headset and phone off and wait for
10 seconds.Turn the headset and phone on again and repeat Steps 1-4.
Turn your headset on
While the headset (HS) is turned off, press and hold the multi function button
until a green LED signal for 1 second and a low tone followed by a high tone
will indicate that the HS is powered up. Once the HS is powered up a green
LED will flash every 3 seconds.
Turn your headset off
While the HS is powered up, press and hold the multi function button S1 for 3
seconds. A high tone followed by a low tone will indicate that the HS is
powered down. The LED indicator will remain red until S1 is released.
Connecting your Bluetooth headset
Pairing needs to be done only once for the initial setup. After the initial pairing
follow these simple steps to connect your Bluetooth headset to your mobile
phone:
● Make sure Bluetooth is enabled on your mobile phone.
● Turn on the headset
After a few seconds the connection between your headset and mobile phone will be
established. If prompted by your mobile phone whether to accept the connection
with the headset please confirm in order to establish the Bluetooth link.You are now
ready to talk!
Bluetooth mono headset
SHB1300/61
Congratulations! You have just bought a state-of-the-art Philips Bluetooth headset.
With the Philips SHB1300/61 you can enjoy convenient hands-free communication
with your Bluetooth enabled phone. This instruction manual will help you to get
started quickly and achieve the best performance from your headset.
Getting started
Charging your headset
Before you use your headset for the first time charge
the battery for 6 hours for optimum battery capacity
and lifetime.
Use only the original charger (5V) for charging the
headset. Using another charger may damage or
destroy your headset!
Plug the AC adapter into the power outlet and
connect the charger cable to the headsets DC socket.
During recharging the LED indicator will show a
steady red light. Charging is completed once the LED
will switch off. Typically a full charge will take 3 hours.
The headset LED will flash red instead of green when
the battery is low and you will hear a short beep every
few minutes. Finish your call before re-charging as
connecting the charger to the headset will put your
headset in charging mode and could cut an ongoing
the call. Once the battery has run out of power you
cannot power the headset on unless the charger is
connected.
Pair your headset to your mobile phone
Your Bluetooth headset must be paired to your mobile
phone before using it for the first time with your phone.
“ Pairing ” will establish a unique encrypted link
between your mobile phone and your headset.
1.Make sure the headset (HS) is turned off, charged
and d isconnected from the charging cable before
you s tart pairing.
4
5
