Rod Antenna
(Not supplied)
VHF/UHF Antenna
(Not supplied)
Connect the antenna
wire to the
ANT(enna) jack on
the TV/DVD.
2C.
Hooking Up Your TV/DVD with an
Indoor Rod Antenna
or a Combined UHF/VHF Antenna
Push the stem of the antenna into the anten-
na hole on the top of the TV/DVD. Connect
the antenna wire to the ANT(enna) Jack on
the back of the TV/DVD.
Extend the rod antenna and adjust its length,
direction, and angle for the clearest picture.
ANT.
ANT.
Connect the red and white audio cables to the
AUDIO OUT jacks on the VCR and to the
AUDIO In jacks on the front of the TV/DVD.
Connect the yellow video cable to
the VIDEO OUT jack on the VCR
and to the VIDEO In jack on the
front of the TV/DVD.
3
Unless you want to connect the TV/DVD to a stereo or decoder, you are finished. Connect
the TV/DVD (and Cable Box, VCR, etc.) to a power source. Go to page 11 to set up your
remote control, then go to page 17 to turn on the TV/DVD. To connect more equipment to your
TV/DVD, refer to pages 9-10.
Hooking Up Your TV/DVD to Another Video
Source
(VCR or Camcorder)
You may need this connection if you want to view videotapes
on the TV/DVD.
When viewing material from other equipment, press the
SELECT button repeatedly until VIDEO appears in the top
right corner of the TV/DVD screen. That indicates that the
TV/DVD is in VIDEO mode and is receiving the programming
from the equipment that is connected to the AUDIO and
VIDEO In jacks on the front of the TV/DVD.
• If the VCR or camcorder only has one audio out jack, use
the white audio cable to connect it to the white AUDIO L
(left) In jack on the front of the TV/DVD.
