Chapter 4 Copy Data Directly by Front USB
Port to TS-101
TS-101 supports direct copy of data on USB devices to TS-101 by using the Copy
button. To use this function, please follow the steps below:
1. Make sure a SATA disk is installed correctly in TS-101 according to the
instructions in Chapter
2.1.
2. Turn on TS-101.
3. Format the SATA disk in SATA Disk page of Device Configuration (refer to
Chapter
3.5.1). A system default folder Qusb will be created in TS-101.
4. Connect USB devices, e.g. digital camera, flash to the front USB port of TS-
101.
5. Press the Copy button on TS-101. All data on the USB device will be copied
to the folder Qusb/(xxxxyyzz)* on TS-101 instantly.
Intelligent One Touch Copy Button#
USB Port
#
Intelligent one touch copy button: TS-101 will detect the data in the connected USB
device automatically. The first time a USB device is connected, press the Copy button and
TS-101 will copy all data in the device automatically. When the same device is connected
again and there are changes to the data in the device, press the Copy button and TS-101
will copy all files in the device. If there are no changes, press the Copy button and TS-101
will not copy the files.
- 101 -
