Page 18
7014-083C
October 26, 2006
CB1200-I Pellet Insert
Rear Vent Installation Preparation:
1. Remove the ENTIRE exhaust blower housing by remov-
ing the 4 nuts using a 7/16" socket wrench. Set the nuts
aside for later use.
2. Remove the 4 screws and remove the vertical exhaust
transition pipe exhaust blower housing.
. Remove any silicone sealant remaining on the blower
housing.
4. Attach the rear vent adapter to the exhaust blower hous-
ing with 4 screws. Figure 18.2.
5. Apply a bead of high temperature silicone adhesive
around the juncture of the blower housing and rear vent
adapter, smoothing it around the joint to ensure that a
good seal is made.
6. Re-install the exhaust blower housing (now with rear vent
adapter attached) with the 4 nuts previously removed in
Step 1.
7. Use 2 screws to attach left corner ller piece of rear
shroud to the insert hopper. Figures 17.1 & 17.2 on
page 17.
8. Install the left shroud corner with 2 screws into the hopper
body and 1 down into ller piece. Figure 18.1.
9. Install cover plate over top vent opening using 4
screws.
Figure 18.1
Figure 18.2
1. Install rear panel using 4 screws along bottom and 2 screws
into the left shroud corner piece at the top. Figure 18.3.
2. If your installation does not include an outside air kit,
attach cover plate with 4 screws.
.
Attach left shroud panel using seven screws, on top and
bottom and 1 along the side. Figure 18.3.
Top Vent Applications: Leave knock-out plate in place.
Figure 18.3
Rear Vent Applications: Clip corners of knock-out plate,
remove and discard, prior to assembling rear shroud kit.
6. Beginning at the right shroud panel drill into hopper body
through the pre-drilled openings and the 2 pre-drilled
openings on the rear shroud panel. Figure 18.5. Continue
around to left shroud corner panel at the 2 pre-drilled
openings. Figure 18.6. Secure with screws to insert.
7. For Top Vent Installation:
Install inch or 4 inch (76 or 102mm) top vent adapter.
See circled area in Figure 17.3 on page 17. NOTE:
This adapter may be attached to outside venting prior to
latching it on to the top vent pipe.
Attaching Shroud to Hopper Body:
Installing Rear Shroud
4.
Assemble the right corner and right panel pieces using 4
screws prior to attaching to insert. Figure 18.4.
5.
After assembly,
attach the right shroud panel/corner
piece
assembly to the insert with screws across the bottom and
1 on the side. Figure 18.4.
Attach right
corner piece to
side panel first.
Right Corner Piece
Right Side
Rear Panel
Outside Air
Cover Plate
Knock-Out
Plate
Rear Panel
Left Side
Drill Holes
Drill Holes
Right Side
Rear Panel
Drill Holes
Left Side
Rear Panel
Figure 18.5
Figure 18.3
Figure 18.4
Figure 18.6
