A SERVICE OF

logo

Indicates the programming status of the target chip in Stand-alone mode.
The PROG LED will light during the cloning process in Stand-alone mode.
Afterwards the LED will flash on/off 3 times to indicate completion:
Fast flashing: (0.1s between flashes) the clone process was a success.
Slow flashing: (1s between flashes) the clone process failed.
If the QTM300CA is not in communication with QT3View software, the PROG LED will
flash on and off.
PROG
Displays the chip type connected via the ribbon cable or in the onboard socket:
QT320OnOn
QT310-On
QT300On-
None--
DeviceDEV0DEV1
DEV0, DEV1
Indicates if QT3View software is communicating with the QTM300CA.
This LED will turn off five seconds after communications have stopped.
PC
Status LEDs
lq
4
QTM300CA/R1.02 25.09.03