Raynger 3i Series Operator’s Manual 2-17
To recall values from the RUN loop, do the following:
1. Release or unlock the trigger, if necessary.
2. Press the RECALL button. The RCL icon will be activated.
3. Press the RUN/LOG button, if necessary, so that the LOG icon is not activated.
4. Read the recalled temperature from the display.
RECALL contains four modes: MAX, MIN, DIF, and AVG (as shown in Figure 2-8).
In RECALL, the last temperature and emissivity setting along with either the MAX,
MIN, DIF, or AVG temperature can be displayed. Note the following:
• Press the MODE button to change modes.
• Press the ▲ or ▼ button to change emissivity. (This shows the effect that a dif-
ferent setting would have. Note that if the target’s temperature is known, you
can determine its emissivity by this method. MAX, MIN, DIF, or AVG are not
updated.)
• Press the backlight button if a brighter display is needed.
2.4.6.2 RECALL Values from LOG
Figure 2-9 illustrates RECALL for LOG values.
Stored temperatures.
all zeros.
and MAX modes.
Stored temperature.
shows all zeros.
