To cancel your program, press and hold
the MODE key in the stop mode. ERASE
will appear on the display. The program
will be automatically canceled.
To exit program mode, press STOP then
PROG.
Random Play
1. Press SHUFFLE until
shows on display.
2. Press PLAY to listen.
3. For de-selection, press SHUFFLE.
PAUSE
Press PLAY to suspend playback
The minutes and secondes flash
when interrupted
STOP
Press STOP to stop playback.
The player switches off automatically
after 5 seconds or press twice STOP key
to turn off your CD player.
REMAIN TIME
Press PROG during playback to read the
remaining playback time.
THE DISPLAY
1.Repeat entire disc
2. Repeat current track
3. Random tracks play
4. ESPX
(When the buffer is being loaded, the
brackets around the ESP symbol will
increase)
5. Program mode
6. Shows when the control button is on
HOLD position.
7. Shows when batteries are low
8. Bass Boost ON
5
THE CD PLAYER
EN
Resume (for RCA only)
When you stop CD play or power off the
unit (without disconnecting power sup-
ply), Resume is automatically activated. It
stores all the current settings and modes:
current track, time display, Mode
(Repeat/Repeat All/ Program/ Random/
Random All), and ESPX. When play mode
is on again, the unit resumes to the set-
tings and plays from where it stopped. If
CD compartment lid is opened, RESUME
stores only the following modes: Shuffle
Mode (Repeat/ Repeat All), EQ setting
(Bass boost/ Surround) and ESPX. Other
settings such as track play, time display,
program setting and memory are all reset
or cancelled.
Repeating
You can replay the entire CD or one
track as many times as you want;
Press MODE repeatedly to
1. Replay the entire disc;
2. Replay the current track;
3. Play the beginning of each track for 10
seconds.
(The number of the track being played will
be displayed and SCAN will appear.)
4. Press again to the function de-select.
Program
This function lets you listen to the tracks
you selected in the order you want. The
CD player must be in Stop mode.
1. Press PROG. P will show on the display.
2. Select the track to be stored by pressing
FWD or REV & press PROG again to
confirm.
3. Repeat step 2 to store other tracks.
4. Press play button to listen to your pro-
gramming.
Note : The unit switches off automatically
after 15s if no key has been activated to
prevent excessive battery consumption.
During programming, the unit can switch
off if you do not press any key within 10s.
If the unit switches off, the programme
will be stored in memory. Resume pro-
gramming by turning the unit on again.
You can program up to 24 tracks.
To play your program again, press PLAY.
To add/edit tracks to the program, go to
stop mode ; press and hold PROG button
again. Refer to step 2 of the above.
To check the program, press PLAY and
FWD.
.
6
THE CD PLAYER
EN
