Programming the Timer (continued)
f
151
The display will prompt you to select either
AM or PM.
ON C" J--I
[] NORM I
Press "1'" for AM or "2" for PM.
The display will prompt you to select the
[6] stopping time.
,,I/ AM I"_ J..._[
OFF -- ,..CH Jl,.,,,.I
/1"
] NORM
Press four digits, two for the hour and two more
for the minute. For example, press 0 8 0 5 for 8:05.
(Always press "0" before a single-digit hour or
minute. The "0 +' will not appear in the display.)
171
The display will prompt you to select either
AM or PM.
D4
oFF LI" U_I ;orcH
] NORM
Press "1" for AM or "2" for PM.
181 The display' will sho_ "START DATE"
followed by the current date and day.
DATE SUN
,_,, lo o'l
J E!
] M NORM D
If you want to start recording on the current
day. skip to Step 9.
If you want to start recording on a future
date, press four digits (two for the month and
two for the day). Press "0" first for a single-
digit month or day. For example, press 0 7 0
9 to begin recording on July 9.
The year and day of the week are displayed
automatically when you finish.
r 1
19] Press PROGRAM to enter your program and [110]
return to the clock display. Additional programs
may be entered by repeating steps 2-9.
-Checking the Timer Programs
Programs can be checked whenever the VCR is turned
on.
I. Press PROGRAM on the remote hand unit to
display the programming menu.
2. Press 5 (Program Review).
The display will show the START TIME,
STOP TIME and START DATE you entered
for the lowest program number at four-second
intervals. Then the display changes to the next
higher program number, and so on until all
program information has been displayed.
3. Press 5 again if you wanl to view the next infor-
mation without waiting four seconds.
4. When you are finished, press PROGRAM to
return to the clock display.
Turn off the VCR. (See "Programming Reminders'"
on page 26.)
-Clearing a Timer Program
1. Press PROGRAM on the remote hand unit to
display the programming menu.
2. Press 5 (Program Review).
The display will show the START TIME,
STOP TIME and START DATE you entered
for the lowest program number at four-second
intervals. Then the display changes to the next
higher program number, and so on until all
program information has been displayed.
3. Press 5 again if you want to view the next infor-
mation withoul waiting four seconds.
4. Press CLEAR when the program information
you want to clear is displayed.
Notes:
• Normal timer programs clear automatically when
the recording is finished, but daily and weekly
programs remain in the timer indefinitely.
• All programs are erased if power is interrupted for
more than approximately ten minutes.
25
