Samson C com 16 Manual

A SERVICE OF

next previous

ENGLISH

4

C com 16 Front Panel Layout

1 PROGRAM LED’S 1- 8

– When illuminated, indi-

cates the associated Program (1-SMOOTH VOCAL,

2-AGGRESSIVE VOCAL, 3-BASS, 4-SLAP BASS, 5-

ACOUSTIC, 6-FUNK GUITAR, 7-SUSTAIN, 8-PERC 1) is

selected.

2

PROGRAM LED’S 9-16

– When illuminated, indi-

cates the associated Program (9-PERC 2, 10-SOFT,

11-DYNAMIC, 12-ENHANCED, 13-STEREO COMP,

14–STEREO LIMIT,15-STEREO MASTER,16-MANUAL) is

selected.

3 PROGRAM SELECTOR

– Rotary encoder control

knob used to select the 16 Programs.

4 GAIN REDUCTION METER

- Displays the amount of

Gain Reduction when Compressor circuit is activated.

5 SENSITIVITY

- Used to set the minimum signal level

at which the Compressor circuit begins to function

.

6 RATIO

- Controls the amount of Gain Reduction in

proportion to the amount of signal over the selected

threshold level.

7 RELEASE

- Selects the amount of time the com-

presssor takes to return the signal to the orignal

level.

8 OUTPUT

- Used to set the final level after the com-

pression circuit is applied.

9 INPUT/OUTPUT METER

- Six segment LED meter

displays the Input or Output signal level based on

the settings of the I/O meter switch.

10 MAINS POWER SWITCH

-

When switched on, the

green LED will light, indicating the C com 16 is

powered on and ready for operation.

11 ENHANCER

- Activates the C com 16’s Enhancer cir-

cuit which restores the high end loss resulting from

extreme Gain Reduction.

12 ATTACK

- Adjusts the amount of time the compres-

sor takes to reach full gain reduction .

13 BYPASS

- Used to switch the C com 16’s compression

circuit on and off. The C com 16 is engaged when

the BYPASS LED lights green.

14

INPUT/ OUTPUT METER SELECT SWITCH

14 INPUT/ OUTPUT METER SELECT SWITCH14

- Selects

either Input or Output level to be displayed on the

Input/Output Meter.

C com 16 Front Panel Layout