Mobile Web 133
3.
To create a new connection profile, touch and follow
the onscreen prompts.
– or –
To edit an existing profile, touch a profile from list, scroll to
the desired field, and use the onscreen keypad/keyboard
to edit the parameter you want to edit:
• Set Name
: enter a profile name.
• Access Name
: edit the access point name.
• Auth Type
: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
•User ID
: enter the User ID required to connect to the network.
•Password
: enter the user password required to connect to the
network.
•Protocol
: set the connection protocol used by the WAP browser:
WAP or HTTP.
•Home URL
: enter the URL address of the page to be used as your
homepage.
• Gateway Address
: (WAP only) enter the gateway address of the
proxy server.
• Proxy Address
: (HTTP only) set the proxy server address and port.
• Secure Connection
: (WAP only) set to On or Off.
• Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there has been no new data traffic in that
time.
• Advanced Settings
: (touch ) allows you to configure some of
the IP-specific information: Static IP, Static DNS, Server information,
and Traffic Class.
–
Static IP
: specify if you want to manually enter an IP address. If you
want the IP address to be automatically assigned by the server, remove
the check mark.
–
Local Phone IP
: enter the IP address obtained from the network
operator, if you checked the Static IP option.
–
Static DNS
: specify if you want to manually enter the Domain Name
Server (DNS) address. If you want the address to be automatically
assigned by the server, remove the check mark.
–
Server 1/Server 2
: enter the Domain Name Server (DNS) addresses.
–
Traffic Class
: select the traffic class.
4. Touch to save these settings.
The WAP settings may vary depending on the service provider.
Save
a697 Crescent.book Page 133 Thursday, March 4, 2010 11:42 AM
