English-5-12
4. FACTORY RESET
- When FACTORY RESET is performed, the setup value will factory default setting when
initialization starts.
1. Select SYSTEM SETUP from MENU screen.
2. From the SYSTEM SETUP submenu, set FACTORY RESET to ON.
3. When you exit MENU, the phrase “FACTORY RESET” appears on the monitor and the initialization
starts.
[ON/OFF]
- Use
,
,
¥
,
, key to make changes.
5. SYSTEM ID
- Runs the remote control when the remote control ID and system ID settings are identical.
Does not run if they are different. [0-9]
- Use
,
,
¥
,
, key to make changes.
6. LANGUAGE
- Show language type of SYSTEM screen.
(ENGLISH)
5-9) NETWORK SETUP
This section of the manual is intended for users who will install this security system in a network
environment.If you have difficulty setting the network,we recommend contacting your network
administrator.
•
Function: Allows users to select the STATIC (fixed) IP, DHCP, PPPoE of Setting.
•
Setting method: Move to #7, NETWORK SETUP MENU by using
KEY in the SETUP
MENU, then press the ENTER SWITCH to display the OSD as shown in the figure below.
(The figure shows the initial setting status)
MOVE TO EACH item by using
KEY, and using
¥
KEY to change the set value.
05/01/05 00:00:01
NETWORK SETTING
1. NETWORK ACCESS STATIC...
2. HTTP PORT 00080
NETWORK STATUS
IP ADDR 192.168.1.200
GATEWAY 192.168.1.65
SUBNETMASK 255.255.255.0
DNS 1 168.126.63.001
DNS 2 168.126.63.002
MAC ADDR 00:30:6f:ff:00:00
• Static
• DHCP
• DSL (PPPoE)
