Section 4: Accessories Installation
SATO M10e Service Manual PN 9001113A Page 4-5
12 Press the LINE/FEED keys to scroll to the desired date and time values and press ENTER
between each.
13 Cycle the printer off and then on again to begin printing.
14 Refer to Programming Manual for command sequences to utilize the real-time clock option.
INTERFACE MODULE UPGRADE
The printer is typically ordered with a high-speed parallel interface card installed. However,
interface requirements sometimes change and an upgrade is desired. All of the interface cards
are installed within the same slot located on the rear of the printer with little or no difference in
installation methodology. Refer to the Interface Board procedure of the Replacement Procedures
section of this manual for directions on this upgrade.
STACKER KIT
The Stacker Kit stacks printed media as it exits the printer. Installation of this purchase option is
not required. Simply follow the instructions included with the product to adjust for media size and
then place the unit against the front housing cover.
MEDIA UNWIND UNIT
The media unwind is designed to dispense rolled media. Installation of this purchase option is not
required. Simply follow instructions included with the product for media loading and orient at the
rear of the printer so that the media may be fed into the printer.
LCD DISPLAY: CALENDAR
YY/MM/DD HH/MM
