14
E
Installation
You can install the touch display for each monitor in the
following positions.
Installation position LL-S242A-W LL-P202V
Standing
position
Rack stand Yes No
Variable stand
No Yes
Pen writing position No Yes
Horizontal position Yes Yes
Installing on a stand
(Standing position)
n
LL-P202V
Placement on the variable stand
Place the unit on the supplied variable stand.
Caution
• The variable stand is designed for placement of the unit in
the landscape orientation. It cannot be used for the portrait
orientation.
• When connecting the stand, spread a soft cloth on a stable
level surface such as a desk, and gently place the monitor
on it with the screen facing down.
• Applying excessive pressure to the LCD panel with your
hands may result in damage to the unit.
• Be careful not to get your ngers caught when adjusting the
angle. There is a risk of injury.
1. Place the variable stand on the rear of the monitor,
insert the xing screws and tighten by hand to position
the stand.
2. Securely tighten the xing screws using the supplied
hexagonal wrench.
3. Place the monitor in the standing position, and adjust
the angle of the stand.
Hold the top of the display with one hand so that it does not
fall over, hold the rear leg of the stand with your other hand,
and adjust the angle of the stand.
The legs can extend about 20 to 75 degrees in relation to
the at surface.
20°
75°
