Basic Operation
-29
"On-screen Display (Example)
➝
➝➝
Using Analog
RGB
Using
Component
INPUT 2 Mode
Using S-Video
INPUT 3 Mode
Using Video
3 Press , or on the re-
mote control to select the IN-
PUT Mode.
• After pressing once, use the but-
ton to select the desired INPUT Mode.
Note
• When no signal is received, “NO
SIGNAL” will be displayed. When a
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
About the INPUT Modes
INPUT 1 Mode
Using
DVI digital
4 Press or on the remote
control to adjust the volume of
the speaker.
Note
• Pressing will raise the volume.
Pressing
will lower the volume.
• On the projector, the volume can be
adjusted by pressing
or .
•
, on the projector operate
as cursor buttons (
, ) when
selecting setup or adjustment
functions while adjusting menus or
the lens.
VOLUME
buttons
Used for projecting im-
ages from equipment that
sends RGB signals or
Component signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
Used for projecting im-
ages from equipment
connected to the S-
VIDEO input terminal.
Used for
projecting
im-
ages
from equipment
connected to the VIDEO
input terminal.
INPUT 1
(RGB/
Component)
INPUT 2
(S-Video)
INPUT 3
(Video)
