1
SBC200 Charger
The SBC200 two-bay charger holds two SBC900 batteries,
transmitters, or bodypacks. It may be used in any appropriate
location with adequate space and ventilation.
Features
• Charge up to two SB900 batteries, body packs or transmitters
• Connect up to four units using one PS45 Power supply
• LED icons for battery status
• Works with compatible hand held and bodypack units such as
the P9RA, P10R, ULXD1, and ULXD2
Included Components
• SBC200 Charger
• PS45 Power Supply (not included with SBC200 model
variation)
• Screws for attaching additional units (8)
• Allen Wrench (hex key)
SB900 batteries not included.
Note:
• This equipment is intended to be used in professional audio
applications.
• EMC conformance is based on the use of supplied and
recommended cable types. The use of other cable types
may degrade EMC performance.
• Use this battery charger only with the Shure charging
modules and battery packs for which it is designed. Use with
other than the specified modules and battery packs may
increase the risk of fire or explosion.
• Changes or modifications not expressly approved by Shure
Incorporated could void your authority to operate this
equipment.
WARNING
• Battery packs may explode or release toxic materials. Risk
of fire or burns. Do not open, crush, modify, disassemble,
heat above 140°F (60°C), or incinerate
• Follow instructions from manufacturer
• Never put batteries in mouth. If swallowed, contact your
physician or local poison control center
• Do not short circuit; may cause burns or catch fire
• Do not charge or use battery packs with other than specified
Shure products
• Dispose of battery packs properly. Check with local vendor
for proper disposal of used battery packs
• Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like
WARNING: Danger of explosion if battery incorrectly
replaced. Operate only with Shure compatible
batteries.
