A SERVICE OF

logo

Photo #1
Step 3:
Threading Lower Looper: (YELLOW)
Slip the thread behind the first guide directly below
the tension dial from right to left.
Slip thread behind the 4 yellow thread guides (these
are indicated by yellow dots below the guide).
Slip thread behind the lower looper using the
tweezers as shown in photo #2, until the thread slips
into the notch located at the far left on the looper.
Next thread the eye of the looper, and then pull the
thread over the top of the upper (orange) looper and
then towards the back of the serger, leaving
approximately 8 inches of thread.