14
Functioning - Model with display
A OFF key (Display off) /Stand-by (led lit on the display)
press for a long time to select the function desired.
B- Lighting, on/off.
C - Timer for selected speed (visualizes the speed selected
and flashing LED on the lower side of the display).
This knob permits the operation of the cooker hood for
a established period:
20 minutes if the speed selected is 1
15 minutes if the speed selected is 2
10 minutes if the speed selected is 3
5 minutes if the intensive speed P is selected.
D - Display showing:
Fan speed (1-3-P).
Change grease filters (grease filter saturation indicator
- F)
After washing the anti-grease filter, depress knob
A for about 3 seconds. The letter F will disappear
from the display.
Change activated carbon filters (carbon filter
saturation indicator - C).
After replacing the charcoal filter, depress knob
A for about 3 seconds. The letter C will disappear from
the display.
When the led in the lower right side is on, it indicates
that the cooker hood is ready for operation (standby
position), the flashing LED indicates that the timer has
been activated for selected speed.
Attention! The active carbon filter saturation indicator
is normally deactivated, to activate it:
Set the hood on OFF (display off), press keys C and
G contemporaneously for 3 secs.
Initially, only letter F will fbe displayed, then after the
3 seconds have passed, letter C will be displayed as
well, indicating that the carbon filter saturation control
system is active.
To switch off the system, re-press the same two
buttons: letter C appear on display and after 3 seconds
letter it disappear and the device will be switched off.
E - Knob to decrease the speed.
F - Knob to increase the speed.
G - Timed intensive speed button: the hood operates at this
speed for 5 minutes and than returns to the previus
settings. The display will show P and a blinking dot.
This function can be cancelled by pressing button A.
If the hood fails to operate correctly, briefly disconnect it from
the mains power supply for almost 5 sec. by pulling out the
plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Warning!
Always press the fan off button A before disconnecting the
hood from the mains supply.
Operation
All cooker hood versions
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking and to leave
in operation during cooking and for another 15 minutes
approximately after terminating cooking.
