
8
Introduction
CONTROLS & INSTRUMENTS
INSTRUMENTS LOCATED ON THE DASHBOARD
A. Hour Meter: Located in tachometer. The Hour Meter indicates the hours of machine operation. The
Hour Meter operates when the ignition switch is on.
B. Tachometer: Indicates engine RPM.
C. Speedometer: The Speedometer indicates ground speed of vehicle in miles per hour.
D. Speed Control: On top is the on/off switch. In the middle is the indicator light. Bottom is the set push
button.
E. Cluster Gauge: Temperature indicator light at 10 o’clock position. Oil pressure light at 2 o’clock
position. Low battery indicator light at 4 o’clock position.
F. Fuel Gauge: Indicates fuel level in tank.
G. Ignition Switch: The Ignition Switch has three positions: Off-Run-Start.
PARK BRAKE
The park brake is attached to steering-column support. To en-
gage park brake, press left foot pedal (K) with foot and push
lever (J) on steering-column support with hand, release foot
pedal before releasing lever. To disengage park brake, push
down on left foot (K) pedal to release the hand lever (J).
TREADLE PEDAL
Located on the right side of floor board. Press top of pedal (L) to
go forward, center is neutral and press bottom of pedal for re-
verse. This pedal controls the ground speed. When starting
engine hydrostat pedal must be centered.
Forward
Reverse