11. To drain tank, open drain valve on manifold.
tank unless pressure is released from
tank by opening valve “C”.
marking liquid in tank, it can be done as follows:
If this is not done, paint can be drawn into the
.
ve “C” is closed.
. Air will enter tank at the top to agitate marking liquid.
. Valve “C” must be closed.
12
WARNING: Do not remove cap from the
AGITATING INSTRUCTIONS (SEE FIG. VI)
If desired to mix the
1. Close valve “A”.
2. Open valve “B”.
NOTE: To keep paint from going down the CO2 Regulator line, be sure to open
valve “A” when agitating is done.
CO2 Regulator, causing damage
3. Make sure val
4. Start engine.
5
TO USE HAND GUN
1. Valve “A” must be open.
2. Valve “B” must be closed.
3
MAINTENANCE INSTRUCTIONS
