8
Attaching the Table-Top Stand
• Refer to the supplied Table-Top Stand instruction leaflet for proper attachment.
• Be careful to not pinch your hands or the AC power cord when you install the TV set to the Table-
Top Stand.
• For best picture quality, do not expose the screen to direct illumination or sunlight.
1 Place the TV set on the Table-Top Stand.
2 Fix the TV to the Table-Top Stand using the supplied screws.
• Hold the TV with one hand to avoid it dropping when attaching.
• Align the TV from the top, slide it in until the guide pins cannot be seen.
• If using an electric screwdriver, set the tightening torque at approximately 1.5 N·m (15 kgf·cm).
• Be sure to securely tighten the supplied screws, otherwise the TV may fall down.
• Use an appropriate screwdriver to attach the screws tightly without damaging the screw head.
• When detaching the Table-Top Stand, reverse the attaching procedure. Do not remove any
screws other than those used when attaching the Table-Top Stand.
Screw (+PSW 5 x 35)
(Supplied)
