11
J
EN
D
F
ES
I
Using the unit in index mode
When more than two monitors are connected via the
CONTROL S connector, you can adjust all the connected
monitors simultaneously using the remote commander
(Normal mode).
If you want to adjust a specific monitor using the remote
commander, set the remote commander to the same index
number as the monitor (Index mode).
Adjusting a specific monitor
1 Press the INDEX button on the monitor you want to
adjust.
The index number of the monitor appears.
2 Press the ID ON button on the remote commander.
The index number of the remote commander appears.
3 Confirm that the index numbers of the monitor and
the remote commander are the same.
4 Press the SET button.
The on-screen display changes from green to yellow.
5 Begin adjusting (page 10).
6 When you finish adjusting, press the remote
commander’s ID OFF button.
The monitor returns to normal mode.
If you press the SET button in step 4 when the
index numbers are different
The on-screen display changes from green to red.
• To continue adjusting, press the ID ON button and set
the remote commander’s index number to the same as
that of the monitor.
• To cancel adjusting, press the ID OFF button and exit
from the index mode.
Setting the index number
The monitor’s index number is set to “0” at the time of
delivery.
To adjust a specific monitor, first identify the index number
of the monitor and set the remote commander to the same
number, then begin adjusting.
1 Press the INDEX button on the monitor.
The index number of the monitor appears.
2 Press the +/– buttons on the monitor to change the
index number.
3 Press the ID OFF button on the remote commander.
Monitor’s index number
INDEX
INDEX ON
No.0
SET INDEX COMMANDER INDEX
No.
No.0
SET INDEX COMMANDER INDEX
No. 1
PRESS ID ON KEY OR ID OFF KEY
ON COMMANDER
