Chapter 7 Menus
116
7-4 Maintenance Menu
1
Using the F/f buttons to select “IP ADDRESS.”
2
Press the g button.
The IP ADDRESS PRESET menu appears, and the
digit that can be changed flashes.
3
Set the IP address.
To select a different digit to be changed
Use the G/g buttons.
To change the value of a digit
Turn the jog dial or shuttle dial.
Turning clockwise increases the value, and turning
counterclockwise decreases the value.
The F/f buttons can be used.
To return to the factory default setting
Press the RESET button.
4
When all digits are set, press the SET button.
This returns to the NETWORK CONFIG menu.
To cancel a setting
Before pressing the SET button, press the MENU
button.
This returns to the NETWORK CONFIG menu,
without saving the new setting.
5
Repeat steps 1 to 4 as required, to set the subnet mask
and default gateway.
6
In the NETWORK CONFIG menu, press the SET
button.
7
When the “NOW SAVING...” message vanishes,
power the unit off and then on again with the on/
standby switch.
Setting the communications speed
Set the communications speed (LINK SPEED) and
communications method (DUPLEX) to match the network
environment.
For details of the operation, see “Basic maintenance menu
operations” (page 114).
IP ADDRESS PRESET
DHCP: disable
IP : 192.168.001.010
SHIFT : (
C
)(
c
)KEY
INC/DEC : JOG DIAL
DATA SET : SET KEY
TO MENU : MENU KEY
CLEAR : RESET KEY
Flashing
Item selection screen
