Getting Started
13
Setting up the remote commander
Master Page : Right
filename[010get.fm] model name1[SLV-SE610A/E] model name2[SLV-SE710D/E]
model name3[SLV-SX710D/E] model name4[SLV-SX717D/E]
model name5[SLV-SE810D/E] model name6[SLV-SX810D]
[3-065-674-E1 (1)]
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• SomebuttonsmaynotworkwithcertainSonyTVs.
* not available on SLV-SE610A/E, SE710D/E, and SX710D/E
Controlling other TVs with the remote commander
(SLV-SX717D/E, SE810D/E, and SX810D only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the following table, set the appropriate manufacturer’s code
number.
* These buttons may not work with all TVs.
Adjust the volume of the TV 2 +/–
Switch to TV (Teletext off)* a (TV)
Switch to Teletext* / (Teletext)
Select the sound AUDIO MONITOR
Use FASTEXT* FASTEXT buttons
Call up the on-screen display
DISPLAY
Change the Teletext page* c/C
Switch to/from wide mode of a Sony wide TV (For
other manufactures’ wide TVs, see “Controlling
other TVs with the remote commander
(SLV-SX717D/E, SE810D/E, and SX810D only)”
below.)
WIDE
1
Set [TV] / [VI DEO] atthetopoftheremotecommanderto[TV] .
2
Hold down ?/1, and enter your TV’s code number using the programme
number buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten’s digit),
PROG +/–, 2 +/–, a (TV), / (Teletext), FASTEXT buttons, WIDE*,
MENU*,
M/m/</,*, and OK*.
To Press
continued
