33
GB
Getting Started
The image quality depends on the connecting
jack. Refer to the illustration that follows.
Select the connection according to the jacks on
your components.
Notes
• Connect image display components such as a TV
monitor or a projector to the MONITOR OUT jack
on the receiver. You may not be able to record, even
if you connect the recording components.
• Turn on the receiver when the video and audio of a
playback component are being output to a TV
through the receiver. If the power supply of the
receiver is not on, neither video nor audio is
transmitted.
Function for conversion of
video signals
This receiver is equipped with a function for
converting video signals. You can output the
video signal after connecting this receiver via
the MONITOR OUT jack as shown in the
illustration.
• Video signals can be output as HDMI video,
component video and S-video signals.
• S-video signals can be output as HDMI
video, component video and video signals.
• Component video signals can be output as
HDMI video, S-video and video signals.
You can switch the function for converting
video signals ON/OFF in VIDEO CONVERT
(page 71). The initial setting is “ON.” When
VIDEO CONVERT is set to “OFF,” the video
signals are not converted.
Video INPUT/OUTPUT jack to be
connected
TV monitor etc., INPUT jack
HDMI
Receiver MONITOR OUT jack
Receiver INPUT jack
Video component OUTPUT jack
Signal
processing
High quality image
COMPONENT
VIDEO
S-VIDEO VIDEO
HDMI
COMPONENT
VIDEO
S-VIDEO VIDEO
HDMI
COMPONENT
VIDEO
S-VIDEO VIDEO
HDMI
COMPONENT
VIDEO
S-VIDEO VIDEO
continued
