1) Begin by tying a knot around the right-most
loop on the main unit. Lace the rope through each
loop, alternating between a main unit loop and a
mounting platform loop.
2) Continue lacing the rope through the loops,
tightening and closing the gap between the two
units as you proceed.
3) Once the rope has been laced through all loops,
tighten rope and tie a knot around the last remain-
ing loop.
As the unit is used, be sure to check the connection and tighten as necessary
INFLATION:
Your Sportsstuff product is equipped with the following types of valves:
NOTICE
When initially unpacked, the recessed speed valve on
this item will have a protective ring within the recessed
portion of the valve base. Remove this protective ring
before inflating and using the trampoline. The ring is
only used to protect the valve during packaging and
shipping and serves no functional purpose once
unpacked and in use.
Recessed Speed Valve - Secure the speed valve by firmly screwing
the bottom portion of the valve into the base. To inflate, unscrew only
the cap (top portion) of the valve. Using the hose from your inflator,
inflate through the top opening of the valve. When fully inflated,
replace the cap by screwing it clockwise onto the bottom portion of
the valve. To deflate, unscrew the bottom portion of the valve from
the base in a counter-clockwise direction.
Speed Safety Valve - Pulls out for fast inflation/
deflation, then can
be pushed in flush with the tube.
Secure the valve by firmly fastening
the bottom portion of the valve into the base. To inflate, open cap or
top portion of the valve. Using the hose from your inflator, inflate
through the top opening of the valve. To deflate, pull the bottom por-
tion of the valve out from the base.
Valve Protective Ring
PVCTrampolinesManual.qxd 3/5/08 3:47 PM Page 4
