restart from the point where it left off when you make
the printer
ready again.
Feeding paper through the printer
There are a number of ways in which you can feed paper
through the printer.
One line or several lines at a time
Make the printer not-ready by pressing the (~]
button, and press the
[PAPER FEED] button. This will feed
the paper forward one line. If you continue to hold down
the [PAPER FEED] button, the printer will continue to feed
A
the paper one line at a time.
Make the printer
ready again to continue printing.
page at a time
‘T~is will either eject a cut sheet or feed fanfold paper to
the top of the next sheet. To determine where the top of
a sheet should be, see “Setting the top of a form” on
page 35.
●
If you want to feed a page of paper through the
printer. make the printer
not-ready. Press and hold
down the
[PAPER FEED] button.
While holding down the
[PAPER FEED] button, press the
m button.
Release both buttons at the same time. The paper will
feed through.
Individual form tear-off
You can tear off individual sheets (for instance, sales
invoices) from fanfold paper.
● While the printer is in ready mode, press and hold
down the [~] button.
● Press the [PAPER FEED] button. The paper will move
- forward about 2 inches (50mm), so that you can tear
off the sheet.
Page34
