www.tanaka-usa.com 15 custsvc@tanaka-ism.com
Owner’s Manual
TBC-250/250PF/PFD,TBC-2501,TBC-2510,TBC-270PF/PFD
-
-
-
-
Maintenance schedule
Below you will find some general maintenance instructions.
For further information please contact your service dealer.
Daily maintenance
• Clean the exterior of the unit.
• Check that the harness is undamaged.
• Check the blade guard for damage or cracks. Change the guard in case of impacts or cracks.
• Make sure the cutting attachment is properly centered, sharp, and without cracks. An off-centered
cutting attachment induces heavy vibrations that may damage the unit.
• Make sure the cutting attachment nut is sufficiently tightened.
• Make sure the blade transport guard is undamaged and that it can be securely fastened.
• Check that nuts and screws are sufficiently tightened.
Weekly maintenance
• Check the starter
• Clean the exterior of the spark plug.
• Remove it and check the electrode gap. Adjust it to 0.6 mm, or change the spark plug.
• Clean the cooling fins on the cylinder and make sure the air intake at the starter is not clogged.
• Make sure the gear case is filled with grease up to ¾ full.
• Clean the air filter.
Monthly maintenance
• Rinse the fuel tank with gasoline.
• Clean the exterior of the carburetor and the space around it.
• Clean the fan and the space around it.
