11
Model H63 Important: To the Operator
Liquid Crystal Display
The Liquid Crystal Display (LCD) islocatedon the front
control panel. The LCD is used to show the current
mode of operation, and whether or not there i s
sufficient mix.
LED Indicator -- MIX LOW
The “MIX LOW” indicator flashes to indicate that there
is a low supply of mix. The mix hopper should be filled
as soon as possible.
LED Indicator -- MIX OUT
The MIX OUT indicator flashes to indicatethat the mix
hopper has an insufficient supply of mix to operate the
freezer. A t this time, the freezer will go into the
STANDBY mode of operat ion. To retur n the freezer to
the AUTO mode, fill the hopper with mix and press the
AUTO key. The freezer will automatically begin
operation.
Consistency Control
The viscosity (thickness) of the shake is cont rolled by
a sensing device called the consistenc y control. The
consistency control knob is located to the lower r ight
of thecontrol channel. To achievea thic ker shake, turn
the knob clockwise and counter clockwise to achievea
thinner shake consistency.
Allow the refrigeration system to cycle on and off 2 or
3 times before an accurate consistency can be
evaluated.
Product Ready Light
The Product Ready Indicat or Light illuminat es when
the product is ready to s erve.
Reset Mechanism
The r eset butt on is locat ed under the right side panel.
The reset mechanism protects the beater motor from
an overload condition. I f an overload occurs, the reset
mechanism will trip. To properly reset the freezer,
press the reset button fir mly and clear the tone per
instruc tions in “Clearing Fault Tones” on page 15.
If the reset mechanism trips again, contact your
authorized Taylor Distributor to resolve the problem.
Warning: Do not use metal objects to
press the reset button. Failure t o comply may
result in severe personal injury or death.
Operating Screen Descriptions
When the machineis powered the system willinitialize.
The screen will display “INI TIALIZING”. Ther e will be
four types of data the system will check: LANGUAGE,
SYSTEM DATA, CONFIG DATA, and LOCKOUT
DATA. During the INITIALIZING... LANGUAGE
screen, the alarm will be on. If the system data,
configuration data, or lockout hist ory data has becom e
corrupt , thefollowing screen will alert the operator that
the system settings may have been changed.
NVRAM FAULT
RESET TO DEFAULTS
PRESS SEL KEY
