Returns the power supply operation mode. When the power supply is On (OUT
1) it will return “CV” or “CC”. When the power supply is OFF (OUT 0 or
Returns the Master/Slave setting. Master: n= 1, 2, 3, or 4 Slave: n=0
1. In Advanced parallel mode (refer to Sec. 5.15.2), “n” is the total system current.
2. In Advanced parallel mode, “MC?” returns
the Master unit current multiplied by the number of slave
7.9 GLOBAL OUTPUT COMMANDS
All supplies, even if not the currently addressed supply, receiving a global command will execute the
command. No response to the PC issuing the comman
d will be returned to the PC. The PC iss
the command will be responsible to delay and any other communications until the command is ex
cute. 200 Ms minimum is the suggested delay.
If the command contains an error, out of range values for example, no er
ror report will be sent to the
Reset. Brings the power supply to a safe and known state:
Output voltage: 0V, output current: 0A, OUT: Off, Remote: RMT 1,
The conditional register (FLT and STAT) are updated. Other registers are
Latching faults (FB, OVP, SO) are cleared, OUT fault stays
Sets the output voltage value in volts. The range of voltage values is shown in T
ay be up to 12 char plus dec. pt
Program the output current value in amperes. The range of current values is
6. ‘n’ may be up to 12 characters plus decimal pt
Turns the output to ON or OFF:
urnoff, clears CV and CC bits in the Status Condition (STAT).
OUT ON will respond with “E07’ if the output cannot be turned on because of a
latching fault (OTP< AC, ENA, SO) shutdown.
Save present settings. Same settings as power
Reference source not found. Except the address and Baud rate are not saved
Saves to the RAM. These settings are erased when the supply power is switched
off and the new ‘last settings’ are saved.
Recall last settings. Settings are fr
down or from last ‘SAV’ or
‘GSAV’ command. Address and Baud rate are not recalled so communication is
