Operating Instructions Teledyne API - Model 200EH/EM Operation Manual
120
To assign an iDAS parameter to a specific analog output channel, press,
EXAMPLE
From the
AIO CONFIGURATION SUBMENU
(See Section 6.13.4.1)
DIAG AIO DATA_OUT_2 5V, NXCNC1, NOCAL
<SET SET> EDIT EXIT
DIAG AIO DATA_OUT_2 DATA: NOCNC1
<SET SET> EDIT EXIT
DIAG AIO DATA_OUT_2 OUTPUT: 5V
SET> EDIT EXIT
DIAG AIO DATA_OUT_2 DATA: STABIL
<SET SET> EDIT EXIT
DIAG ANALOG I/O CONFIGURATION
PREV NEXT ENTR EXIT
Use these keys to move up
and down the list if available
iDAS parameters
(See Table A-6 of Appendix A.5)
Continue pressing SET> until ...
Continue pressing SET> until you reach the
output to be configured
DIAG AIO AOUTS CALIBRATED: NO
SET> CAL EXIT
DIAG AIO DATA_OUT_2 DATA: NOCNC1
PREV NEXT ENTR EXIT
DIAG AIO DATA_OUT_2 DATA: STABIL
<CH CH> INS DEL [1] ENTR EXIT
