171
10. MAINTENANCE SCHEDULE & PROCEDURES
The T801 Analyzer utilizes technologies that are non-depleting and require very
little maintenance. However, there are a minimal number of simple procedures
that when performed regularly will ensure that the analyzer continues to operate
accurately and reliably over its lifetime. Repairs and troubleshooting are covered
in Section 11 of this manual.
10.1. MAINTENANCE SCHEDULE
Table 10-1 shows a typical maintenance schedule for the analyzer. Please note
that in certain environments (i.e. dusty, very high ambient pollutant levels) some
maintenance procedures may need to be performed more often than shown.
Note
A Span and Zero Calibration Check (see CAL CHECK REQ’D Column of Table
10-1) must be performed following certain of the maintenance procedure
listed below.
CAUTION
GENERAL SAFETY HAZARD
Risk of electrical shock. Disconnect power before performing any of the following operations
that require entry into the interior of the analyzer.
CAUTION
QUALIFIED PERSONNEL
The operations outlined in this Section are to be performed by qualified maintenance
personnel only.
