ADJUSTING THE STITCH LENGTH AND PATTERN
STITCH SELECTION
To avoid needle or fabric damage, make sure the
needle is fully raised before selecting a stitch.
1; Raise the needle above the fabric.
2: Select the desired stitch length/pattern by rotating the Stitch Selector until the
appropriate letter aligns with the setting mark at the top.
3: Follow the Stitch Setting Guide to set your machine for the desired result.
A Note on ZIgZag stitching tensions
1: For an ideal zigzag stitch, the bobbin thread
does not show on the right side (top side) of the
fabric and the needle thread shows slightly on the
wrong side (Bottom side) of the fabric.
A
B
C
D
E
F
G
H
A
B
C D
E F
G
H
SYMBOL LETTER
STITCH CARD
SETTING MARK
Stitch Setting Guide
A-D: Straight Stitch - Centre Needle Position.
There are 16 positions from letter A-D. This allows you to
ne-tune the stitch length from ne to extra long.
E: Straight Stitch - Right Needle Position, Medium Stitch
Stitch length in this position is the same as letter C above.
F-H: ZigZag Stitch.
Three settings, each letter selects one preset stitch length
Page 13
