3
3. Open Filter access door and remove it. Also
remove both collector cells or media filter and
set aside being careful not to damage either.
4. Install eyebolts provided with unit as shown in
Sketch A.
5. Select mounting location as near to the center of
the area to be cleaned or at the point
recommended by your TRION Representative.
Remove a section of ceiling tile.
6. Attach a length of safety chain (2.0 Min.) or
equivalent rod, cable or other hanger material to
each of the four eyebolts. Fasten securely. See
Sketch A.
7. Lift unit into place and support while securing to
permanent ceiling, ceiling joist, etc. (See Sketch
B)
CAUTION:
DO NOT ALLOW FULL WEIGHT OF UNIT TO REST
ON T-BAR CEILING.
8. Install mounting trim brackets to each side to fill
in the gap between the unit and T-Bar.
9. Connect electrical power to the unit. See Wiring
Diagram.
10. If optional carbon filter is used, remove filter
from plastic bag and install in the guide rails
provided inside the cabinet behind the main
filter. Replace the main filter and pre-filter / door
assembly. Close the door and secure by turning
the quarter turn fasteners clockwise with a coin
or screwdriver. The unit is now ready for
operation.
The following information will be required for prompt
delivery of repair parts:
Description Located
1. Unit model number Inside door
2. Unit serial number Inside door
3. Part number and description Exploded views.
When a part number is not listed, give the above
information and include the item number from the
exploded views.
MAINTENANCE AND WASHING
MAINTENANCE
When to Wash: Periodically the dirt collected by your
unit must be removed. The frequency of washing will
depend on the amount of dirt present in the air in your
locality.
The washing frequency best suited for your unit can be
determined by examining the dirt collected components
at three week intervals. As the dirt begins to collect, you
