SNMP CONFIG.
5
Connection
optional
Your UPS will function properly without these connections.
Serial Port Connection
Using the serial cable provided, connect a serial port
from a computer to a serial port on your UPS. Install
on the computer the Tripp Lite power protection software
appropriate to its operating system.
USB Port Connection
Using the USB cable provided, connect a USB port
from a computer to a USB port on your UPS. Install
on the computer the Tripp Lite power protection software
appropriate to its operating system.
EPO Port Connection
Using the RJ-11 cable provided, connect the
Emergency Power Off (EPO) port of your computer to
a user-supplied normally closed or normally open
switch according to the circuit diagram at the right.
The EPO port is not a phone line surge suppressor; do
not connect a phone line to this port.
1
SNMP CONFIG.
N.C. EPO SWITCH
N.O. EPO SWITCH
200210187 Smart 700-1000 RM1U Owner’s Manual 93-2102.qxd 11/1/2002 9:50 AM Page 5
