Tripp Lite SMART2600RM2U Manual

A SERVICE OF

next previous

15

YES

Basic Operation continued

Tap the button repeatedly to advance to Sensitivity display, as shown on the previous page.

Press the button to advance through the options. The last option displayed, before navigating

away from this menu option, will be the selected setting.

External Battery Setting Control (Select Models)

ThiscontrolmenuoptiononlyappearswhentheUPSisconfiguredusingtheExternalBatteryUtility

softwareandisreporting“YES”intheExternalBatteryLCDControlScreen.TheonlyavailableLCD

interfaceconfigurationoptionistochangethesettingfrom“YES”to“NO”externalbatteries.

Note: See the Optional Installation section for information on configuring the UPS for external battery operation

using the External Battery Utility software.

Tap the buttonrepeatedlytoadvancetotheExternalBatterydisplay,asshownabove.

TosettheUPSto“NO”ExternalBattery,pressandholdthe buttonfor3.5seconds.

Note: The Battery Runtime calculation is based on this setting. The runtime and charger rate will automatically

recalculate once the external battery setting is configured for “NO” external batteries.

Factory Mode Reset

TheLCDsettingscanberestoredtoFactoryModebyholdingtheMODEandENTER/MUTEbuttons

simultaneouslyfor5secondswhileinanydisplaymode.

CAUTION: This action cannot be undone. The user must reconfigure the UPS for external

batteries if the UPS’s setup includes external batteries.

12-12-037-93-3088-B.indb 15 12/26/2012 3:47:33 PM