3
3 – SRSWITCH Installation
The switch and magnet are designed to be mounted at the top of a SmartRack Premium Rack Enclosure. Magnet should be mounted ush against the inside
edge of the Rack Enclosure door. Attach the switch to the outside of the Rack Enclosure cabinet and make sure both switch and magnet are in alignment.
The switch and magnet should be mounted on the side of the enclosure opposite the hinges.
Note: the switch and magnet do not need to make physical contact but should be no more than ¼ inch (6.35 mm) apart.
3-1 Mounting the Switch and Magnet to the Rack Enclosure
3-2 Wiring the Switch
The double-sided tape on both the switch and magnet allow you to mount
them to a rack enclosure without any drilling.
Mark the intended location of both the switch and the magnet.1.
Peel the paper backing off the adhesive strip attached to the back 2.
of the switch.
Place the switch in the desired location. Press rmly.3.
Repeat steps 2 and 3 to mount the magnet.4.
Before attaching the wire to the switch, use wire cutters to clip to 1.
desired length (if necessary).
Use wire strippers to cut back the covering of the two wires and remove 2.
a small amount of insulation from the end of each wire. (Do not cut
through the insulation into the wire itself.)
Twist the bare ends of the wire, place them under the head of each 3.
screw on the switch and then wrap the wire clockwise around the screw.
Tighten the screw by turning it clockwise.
Use the cable ties and adhesive cable tie holders (included) to secure 4.
the entire length of the wire.
Route the wire away from the switch and magnet and attach to one of 5.
the security inputs on the ENVIROSENSE (see Section 4-1).
Note: Make sure the wire is not pinched by any part of the rack
enclosure or its door.
Approximately 1 in. (25.4 mm)
Approximately 0.38 in. (9.7 mm)
SmartRack Enclosure
(Front Door Open)
Magnet: Attaches to Door
SmartRack Enclosure
(Back Door Open)
MagnetSwitch
Right Wrong
Switch: Attaches to Cabinet
Switch: Attaches to Cabinet
Magnet: Attaches to Door
