EXTERNAL BATTERY PACK CONNECTION
(SUGK:
Optional;
SU1OK:
Required)
Since SUGK models contain internal batteries, connecting external battery packs (to
extend runtime) is optional.
SUlOKPM models, however. do not have internal batteries
and require an external battery pack connection to a
SUlOKBP or a SUBP. Using the
supplied battery connection cable, insert one end into the External Battery Connector
on the rear panel of your UPS and the other end into the Battery Output Connector on
the rear panel of the external battery pack. Use the plug on either end of the supplied
cable, but make sure that it is fully inserted into the connector. See figure below for
daisy-chaining one or more external battery packs to your UPS.
SUBP SUlOKBP SUlOKPM
Note: Optional Tripp Lite external battery packs (SUBP's) feature individual 120V AC
input line cords and individual internal battery chargers. By adding multiple SUBP's
individually connected to 120V AC input, the recharge time of a battery system will be
dramatically reduced as compared to systems relying on only the
UPS'S main charger.
While adding SUBP's without connecting their chargers will increase a battery system's
reserve capacity, this
will also
increase the system's overall
recharge time. See the figure to the
Acmpu,
right for the schematic diagram of
1
avo
the SUBP external battery pack.
BArrERY FUSE
REPLACEMENT
THE DIAORAU
OF
THE EXTENSIBLE BATTERY CABINET
If
one of your fuses has blown, you will
notice no output voltage at zero load. Blown
fuses should be replaced
as
shown
in
the
diagram on the right. Since SUGK models
f
contain internal batteries, the battery fuse
holders are located on the rear panel of the
UPS. Since
SUlOK models operate solely
from external batteries, the battery
fuse holders are located on the rear panel of the external battery
pack(s). Note: SUGK
models also support connections to optional external battery packs, which may require
battery fuse replacement.
