10
Connector Pinout Diagrams / Slide Switch Setting
+13.8 V OUT
TX GND
GND
BAND DATA A
TX-INH
EXT ALC Input
TX REQ
BAND DATA B
BAND DATA C
BAND DATA D
MIC Jack GPS Jack
ACC Jack TUNE Jack DATA Jack
(
As Viewed From Rear Panel
)(
As Viewed From Rear Panel
)
(
As Viewed From Rear Panel
)
(
As Viewed From Rear Panel
)(
As Viewed From Front Panel
)
P ENB
CNTL GND
PTT
MIC
MIC GND
UP
DOWN
+ 5V
Max. 1 A
This terminal is connected
in parallel with the pin 1 of
TUNE Jack.
Open Collector
(Max. 60 V, 1A)
This terminal is connected
in parallel with the pin 2 of
TUNE Jack.
+13.8 V
TX GND
Pin 1
Pin 2
Max. 1 A
This terminal is connected
in parallel with the pin 1 of
ACC Jack.
Open Collector
(Max. 60 V, 1A)
This terminal is connected
in parallel with the pin 2 of
ACC Jack.
+13.8 V
TX GND
Pin 1
Pin 2
Open Circuit Voltage: 5 V, Closed Circuit Current: 1 mAPTTPin 3
60 mVp-p @1 kΩ.
500 mVp-p @1 kΩ
SQL OPEN: 5 V
SQL CLOSE: 0 V
DATA IN
DATA OUT
SQL OUT
Pin 1
Pin 5
Pin 6
Connected with , , , and .
GPS Data Input (
+
)
N/C
Connected with , , , and .
Connected with , , , and .
Connected with , , , and .
Connected with , , , and .
NC
GPS Data Input
(
--
)
DATA IN
GND
DATA PTT
DCD
DATA OUT
SQL OUT
ON: Disables the Memory Channel Storage from the transceiver.
OFF: Enables the Memory Channel Storage from the transceiver.
ON: Enables the ITU Memory Channel Operation.
OFF: Disables the ITU Memory Channel Operation.
This switch should always be set to "OFF."
This switch should always be set to "OFF."
Memory Channel Storage
ITU Memory Channel
---
---
Switch 1
Switch 2
Switch 3
Switch 4
Slide Switch
(
Located on the MAIN Unit
)
Accessory Port
(
Located on the MAIN Unit
)
+13.8 V OUT
TX GND
GND
RX D
TX D
RESET
TX-INH
TUNER SENSE
ENCR_TXIN
ENCR_RXIN
INDICATOR
CODE
(
8
)
ENCR_RXOUT
CLEAR/SCRAMBLE
PTT
VCC
GND
ENCR_TXOUT
CODE
(
4
)
CODE
(
2
)
CODE
(
1
)
