Indicates the lamp has been used for more than 1900
Indicates that lamp usage time (about 2000 hours)
is exceeded. Please contact your Vidikron dealer to
Blinking: Indicates the temperature inside the projector is
Light On: During projection.
When this projector is in standby mode, pressing this button
for more than 1 second will turn the projector on and cause the
[POWER] indicator to light up. Press it one second or more again,
and the projector goes into the cool down mode and fi nally into
• The [POWER] button will not work within approximately 1
minute of the light-source lamp being turned on. Hence wait
about 1 minute before pressing.
Press this button to enter or exit the menu mode. When the
main menu is displayed, pressing this button will cause the
Press this button to display the previous menu (For example,
from sub menu to main menu). Pressing this button when the
main menu is displayed will clear the menu.
These buttons are used in the menu mode to select an item,
Press this button to show the next hierarchical menu (for
example, to enter submenu from main menu). It is also used
when “ENTER” is displayed against a selection item on the menu
Use this button to reset the values to factory settings when the
“Gamma”, “White Bal.”, “Blanking” or “Picture Adjust” item in the
Use this button to temporarily halt the video output. Press again
Control Panel on the Projector
Controls and Features (continued)
Access to this item requires opening the Chassis Cover. For instruc-
tions on how to remove the Chassis Cover see Page 10.
