ELECTRIC FRYERS - SERVICE PROCEDURES AND ADJUSTMENTS
13
COMPUTER CONTROL TEST
1. Check for 24 VAC at pin 1 (and pin 2 on split
vat fryer) referenced to pin 13.
2. Check for 12 to 16 VDC between pins 23 and
24.
3. Verify probe thermistor operation as outlined
under “THERMISTOR PROBE RESISTANCE
CHART”.
4. Check output for 24 VAC at pin 15 (and pin 16
for split vat fryer) when calling for heat.
Reference to pin 13.
5. Check output for 24 VAC at pin 14 (and pin 19
on split vat fryers) when in a cook cycle.
Reference to pin 13.
6. Replace computer control if outputs are not
correct.
LIFT ASSIST SPRING
ADJUSTMENT
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. THERE MAY BE TWO SEPARATE
CIRCUITS. BE SURE BOTH ARE
DISCONNECTED. PLACE A TAG ON THE
CIRCUIT BOX INDICATING THE CIRCUIT IS
BEING SERVICED.
1. Remove rear access cover by prying out on top
edge with small screwdriver.
2. Adjust all spring hooks evenly so that elements
stay in the raised position when lifted.
3. Install rear cover.
TILT SWITCH ADJUSTMENT
WARNING:
DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. THERE MAY BE TWO SEPARATE
CIRCUITS. BE SURE BOTH ARE
DISCONNECTED. PLACE A TAG ON THE
CIRCUIT BOX INDICATING THE CIRCUIT IS
BEING SERVICED.
1. Remove head cover screws.
2. Lift head cover enough to access tilt switch
mounting screws.
NOTE:
Do not bend or kink high limit capillary tube.
3. With oil at level mark on vat, switch should
operate to shut off elements before front of
elements leave oil. Loosen switch mounting
screws and adjust switch as required.
4. Install head cover.
